Yamaha RX-V620RDS owner manual SUBWOOFER jack, Preparation, English

CONNECTIONS

Main speakers A Main speakers B

Right Left Right Left

(Europe model)

VD		+	–	SPEAKERS	+
	R			–		L
/CBL	A
	MAIN
TOR
T	B
COMPONENT VIDEO
MONITOR OUT						OUTPUT

RL

VIDEO	MAIN
CENTER

+–

MAINS

AC OUTLETS

PREPARATION

					R	L
S VIDEO					REAR
					(SURROUND)
								SWITCHED
	+	–	–	+	CENTER			100W MAX. TOTAL
R						IMPEDANCE SELECTOR
					L
						SET BEFORE POWER ON		MAIN A OR B: 8		MIN. /SPEAKER
								A + B:16 MIN. /SPEAKER
								CENTER	: 8	MIN. /SPEAKER
REAR								REAR	: 8	MIN. /SPEAKER
(SURROUND)						MAIN A OR B: 4		MIN. /SPEAKER
SUB							A + B: 8 MIN. /SPEAKER
						CENTER	: 6	MIN. /SPEAKER
WOOFER						REAR	: 6	MIN. /SPEAKER
OUTPUT

Right Left

Subwoofer Center speaker	Rear speakers
system

■SUBWOOFER jack

When using a subwoofer with built-in amplifier, including the YAMAHA Active Servo Processing Subwoofer System, connect the input jack of the subwoofer system to this jack. Low bass signals distributed from the main, center and/or rear channels are directed to this jack. (The cut-off frequency of this jack is 90 Hz.) The LFE (low-frequency effect) signals generated when Dolby Digital or DTS is decoded are also directed if they are assigned to this jack.

Notes

•Adjust the subwoofer volume according to the operating instructions for the subwoofer. (Fine adjustment is possible using this unit’s output level control of the effect speakers.)

•Depending on the settings of “1 SPEAKER SET”, “6 DOLBY D. SET” and “7 DTS SET” on the SET MENU, some signals may not be output from the SUBWOOFER jack.

English

17