Yamaha RX-V620RDS IMPEDANCE SELECTOR Switch, Connecting the Power Supply Cords, English

CONNECTIONS

IMPEDANCE SELECTOR Switch

WARNING

Do not change the IMPEDANCE SELECTOR switch setting while the power of this unit is on, otherwise the unit may be damaged.

If this unit fails to turn on when STANDBY/ON (or POWER) is pressed, the IMPEDANCE SELECTOR switch may not be fully slid to either position. If so, slide the switch to either position fully when this unit is in the standby mode.

Select the left or right position according to the impedance of the speakers in your system. Be sure to move this switch only when this unit is in the standby mode.

							(Europe model)				PREPARATION
								Left	Speaker	each speaker must be 8 Ω or higher.
								Switch		Impedance level
								position
										If you use one set of main speakers, the impedance of
					MAINS					each speaker must be 4 Ω or higher.
									Main
				AC OUTLETS						If you use two sets of main speakers, the impedance of
									Center	The impedance must be 6 Ω or higher.
									Rear	The impedance of each speaker must be 6 Ω or higher.
										If you use one set of main speakers, the impedance of
									Main	each speaker must be 8 Ω or higher.
				SWITCHED
	SET BEFORE POWER ON			100W MAX. TOTAL						If you use two sets of main speakers, the impedance of
IMPEDANCE SELECTOR
				MAIN A OR B: 8			MIN. /SPEAKER			each speaker must be 16 Ω or higher.
					A + B:16 MIN. /SPEAKER			Right
				CENTER		: 8	MIN. /SPEAKER
				REAR		: 8	MIN. /SPEAKER
									Center	The impedance must be 8 Ω or higher.
		MAIN A OR B: 4		MIN. /SPEAKER
			A + B: 8 MIN. /SPEAKER
		CENTER	: 6	MIN. /SPEAKER					Rear	The impedance of each speaker must be 8 Ω or higher.
		REAR	: 6	MIN. /SPEAKER

IMPEDANCE SELECTOR

Connecting the Power Supply Cords

After completing all connections, connect the AC power cord to an AC power outlet. Disconnect the AC power cord if you will not use this unit for a long period of time.

■AC OUTLET(S) (SWITCHED)

(Europe model)

Europe model	2 OUTLETS
U.K. model	1 OUTLET

MAINS

AC OUTLETS

SWITCHED

100W MAX. TOTAL

IMPEDANCE SELECTOR

SET BEFORE POWER ON				MAIN A OR B: 8		MIN. /SPEAKER
				A + B:16 MIN. /SPEAKER
				CENTER	: 8	MIN. /SPEAKER
				REAR	: 8	MIN. /SPEAKER
	MAIN A OR B: 4		MIN. /SPEAKER
		A + B: 8 MIN. /SPEAKER
	CENTER	: 6	MIN. /SPEAKER
	REAR	: 6	MIN. /SPEAKER

To AC outlet

Use these outlets to connect the power cords only from your audio/video components to this unit. The power to the AC OUTLET(S) is controlled by this unit’s STANDBY/ON (or POWER and STANDBY). These outlets will supply power to any connected component whenever this unit is turned on. The maximum power (total power consumption of components) that can be connected to the AC OUTLET(S) is 100 W.

English

SWITCHED

19