Yamaha RX-V620RDS Changing Parameter Settings, Resetting a Parameter to the Factory-setValue

Changing Parameter Settings

Although it is possible to enjoy playback on your system without changing default setting parameters for the sound field program, it is also possible to enjoy specifically tailor the sound field program to the characteristics of the source and the acoustics of the listening room.

3	A/B/C/D/E	2
1		4
		5

3

A/B/C/D/E

1 Set the selector dial to the DSP/TUN (or

AMP/TUN) position.

or

2 Turn on the video monitor and press ON SCREEN repeatedly to select the full display mode.

3 Select a DSP program you want to adjust.

Program No. Program name (group)

P07 MOVIE THEATER 1

70mm Spectacle

Cursor P. INIT. DLY • • 13ms

P.ROOM SIZE • • 1.0 S. DELAY • • • • • 23ms S. ROOM SIZE • • 1.0

Parameters

Example of the MOVIE THEATER 1

SOUND FIELD PROGRAM PARAMETER EDITING

4 Press u/d to select the parameter.

5 Press j / i to change the parameter value.

y

•When you set the parameter to a value other than the factory- set value, an asterisk mark (*) appears by the parameter name on the video monitor.

6 Repeat steps 3 to 5 above as necessary to change other program parameters.

Memory back-up

The memory back-up circuit prevents the stored data from being lost even if this unit is set in the standby mode, the power cord is disconnected from the AC outlet, or the power supply is temporarily cut due to power failure. However, if the power is cut for more than one week, the parameter value you edited will return to the factory setting. If so, edit the parameter value again.

Resetting a Parameter to the

Factory-set Value

Select the parameter you want to reset. Then press and hold j or i until the value temporarily stops at the factory-set value. The asterisk mark (*) by the parameter name disappears on the video monitor.

Notes

•The available parameters may be displayed on more than one OSD page for some of the programs. To scroll through pages, press u/d.

•You cannot change parameter values when “10 MEMORY GUARD” on the SET MENU is set to ON. If you want to change the parameter values, set “10 MEMORY GUARD” to OFF.

INFORMATION ADDITIONAL

English

59