Yamaha RX-V620RDS owner manual Basic Recording, Start recording on the recording component

BASIC RECORDING

Recording adjustments and other operations are performed from the recording components. Refer to the operation instructions for these components.

VOLUME

	RDS MODE/FREQ	EON
STANDBY	PTY SEEK
/ON	MODE	START

INPUT MODE 6CH INPUT

BASS

BASS

TREBLE

SPEAKERS

INPUT

EXTENSION

A

B

DSP

PRESET

TUNING

EFFECT

PROGRAM

/TUNING

FM/AM

MEMORY

MODE

ON

OFF

–

+

–

+

ON

OFF

EDIT

MAN'L/AUTO FM

AUTO/MAN'L MONO

PHONES

S VIDEO

VIDEO

L AUDIO

R

OPTICAL

SILENT

VIDEO AUX

2

2

A/B/C/D/E

1 Turn on the power to the unit and all connected component.

2 Select the source component you want to record from.

INPUT

or

Front panel Remote control

3 Start playback (or select a broadcast station) on the source component.

4 Start recording on the recording component.

Notes

•Do a test recording before you start an actual recording.

•When this unit is set in the standby mode, you cannot record between other components connected to this unit.

•The setting of BASS, TREBLE, BASS EXTENSION, VOLUME, “2 L/R BALANCE” on the SET MENU and DSP programs does not affect the recorded material.

•A source connected to the 6CH INPUT jacks of this unit cannot be recorded.

•S-video and composite video signals pass independently through this unit’s video circuits. Therefore, when recording or dubbing video signals, if your video source component is connected to provide only an S-video (or only a composite video) signal, you can record only an S-video (or only a composite video) signal by your VCR.

•A given input source is not output on the same REC OUT channel. (For example, the signal input from VCR 1 IN is not output on VCR 1 OUT.)

•Check the copyright laws in your country to record from records, CDs, radio, etc. Recording of copyrighted material may infringe copyright laws.

If you playback a video source that uses scrambled or encoded signals to prevent it from being dubbed, the picture itself may be disturbed due to those signals.

■Special considerations when recording DTS software

The DTS signal is a digital bitstream. Attempting to digitally record the DTS bitstream will result in noise being recorded. Therefore, if you want to use this unit to record sources that have DTS signals recorded on them, the following considerations and adjustments need to be made.

For DVDs and CDs encoded with DTS

Only 2-channel analog audio signals may be recorded. Set the DVD player (or CD player) as described in the player’s operation instructions so that the audio signals are output from the player’s analog outputs.

38