CTONE BYPASS switch

When this switch is pressed inward (ON), the input signal does not pass through the tone (BASS and TREBLE) control circuitry so that it is unaffected by the tone control circuitry. Use this switch to obtain pure sound and to check the tone control setting. Press this switch to release it outward (OFF) to use the tone control circuitry.

DBASS and TREBLE Controls

Adjust low and high frequency response respectively for the main channels only.

EBALANCE Control

Adjusts the left and right output volume to the Main Speakers to compensate for sound imbalance caused by speaker positions or listening room conditions.

FPreset Station Number Selector Buttons Select a preset station number (1 to 8).

GREC OUT Selector

Selects the source to be recorded to a tape deck or

VCR independently of the setting of the input selector buttons. However, when set to the SOURCE position, the setting of the input selector buttons decides the source to be recorded to a tape deck or VCR.

HFM/AM Switch

Press this switch to switch the reception band to FM or AM.

IMEMORY (MAN’L/AUTO FM) Button

When this button is pressed, the MEMORY indicator flashes for about 5 seconds. During this period, select a desired preset station number by pressing the corresponding preset station number selector button to enter the displayed station into the memory.

When this button is pressed and held for about 3 seconds, the automatic preset tuning begins. (Refer to page 52 for details.)

JTUNING DOWN/UP Button

English

Used for tuning. Press the “UP” side to tune in to higher

 

frequencies, and press the “DOWN” side to tune in to lower

 

frequencies.

 

 

KEDIT Button

This button is used to exchange the places of two preset stations with each other.

LTUNING MODE (AUTO/MAN’L MONO) Switch

Press this switch to switch the tuning mode to automatic or manual. To select the automatic tuning mode, press this switch so that “AUTO TUNING” lights up on the display panel. To select the manual tuning mode, press this switch so that “AUTO TUNING” goes off.

MDELAY/C/R/F/SWFR Switch

Whenever pressed, selects the item of changing delay time, center speaker output level, rear speaker output level, front effect speaker output level and subwoofer output level in turn.

*Depending on a mode of this unit, the number of selections is reduced. For example, when the built-in digital sound field processor (including the Dolby Pro Logic Decoder or the Dolby Digital (AC-3) Decoder) is off, only the item for changing subwoofer output level can be selected.

N–/+ Button

Adjusts the level of item selected by pressing the DELAY/C/R/F/SWFR switch. Moreover, performs setting changes and adjustments for functions selected by pressing the SET MENU switch.

OSET MENU Switch

Whenever pressed, selects functions in the SET MENU mode.

15