CROOM 2 OUT Jacks

These jacks output audio and video signals to the equipment in the second room. The input source selection is made using the Room 2 remote control unit. Refer to “CONNECTING AND CONTROLLING ROOM 2 EQUIPMENT” on page 38.

DREMOTE CONTROL IN and OUT Jacks

The IN jack receives the commands from the Room 2 remote control unit. The OUT jack outputs the commands at the IN jack from the Room 2 remote control unit. Refer to “CONNECTING AND CONTROLLING ROOM 2 EQUIPMENT” on page 38.

EVideo NTSC/PAL Switch (General Model only)

Set this switch to the position corresponding to the standard that your video equipment employs.

FFRONT MIX Switch

Set to “OFF (7ch)” when setting up a full 7 or 6 speaker system, or to “ON (5ch)” when setting up a 5 or 4 speaker system.

GMAIN LEVEL Switch

Normally set to “0 dB”. If desired, you can decrease the main- channel output level at the MAIN SPEAKERS terminals by 10 dB by setting this switch to “–10 dB”.

HPRE OUT Jacks

Main-channel line output. Connected with jumper bars to MAIN IN jacks when the built-in amplifier is used. Connected to input jacks of external stereo power amplifier (MAIN IN or TAPE PLAY jacks of integrated amplifier or receiver) when using external amplification.

IMAIN IN Jacks

Line input to built-in main-channel amplifier. Connected with jumper bars to PRE OUT jacks when the built-in amplifier is used. Not connected when using an external power amplifier.

JSUBWOOFER Jacks

When using one subwoofer, connect its amplifier input to either of these jacks. When using two subwoofers, connect their amplifiers to these jacks respectively.

Frequencies below 90 Hz distributed from the main, center and/or rear channels are output to these jacks.

Signals of LFE (low frequency effect) generated when the Dolby Digital (AC-3) is decoded are also output if they are assigned to these jacks.

KFRONT EFFECT OUTPUT Jacks

Front-channel line output. Can be connected to input jacks of an external stereo power amplifier driving the front effect speakers.

20