Switching the IMPEDANCE SELECTOR switch on the rear panel
Select the position whose requirements your speaker system meets. Be sure to switch this only when the power of this unit is turned off.
VOLTAGE SELECTOR
AC OUTLETS
SWITCHED
I20V
60Hz
I00W
MAX.
TOTAL
IMPEDANCE SELECTOR
ACENTER C OR D: 4ΩMIN./ SPEAKER
SET SPEAKER MODE 
ΩMIN./ SPEAKERC D: 4
|
| SET SPEAKER MODE |
|
| REAR | 6ΩMIN./ SPEAKER | IMPEDANCE |
B | MAIN A OR B: 4ΩMIN./ SPEAKER | ||
CENTER C OR D: 8ΩMIN./ SPEAKER | |||
| A | B: 8ΩMIN./ SPEAKER |
|
| FRONT EFFECT: 6ΩMIN./ SPEAKER |
| |
| C | SET SPEAKER MODE | SELECTOR |
| D: 4ΩMIN./ SPEAKER | ||
| MAIN A OR B: 8ΩMIN./ SPEAKER | ||
|
| SET SPEAKER MODE |
|
| REAR | 8ΩMIN./ SPEAKER |
|
AB: 6ΩMIN./ SPEAKER FRONT EFFECT: 8ΩMIN./ SPEAKER
(General model)
WARNING
Do not change the IMPEDANCE SELECTOR switch setting while the power to this unit is on, otherwise this unit may be damaged.
IF THIS UNIT FAILS TO TURN ON WHEN THE POWER SWITCH IS PRESSED
The IMPEDANCE SELECTOR switch may not be set to either end closely. If so, set the switch to either end closely.
(Upper position)
Center: If you use one center speaker, the impedance of the speaker must be 4Ω or higher.
If you use two center speakers, the impedance of each speaker must be 4Ω or higher.
Rear: (U.S.A. and Canada models:)
The impedance of each speaker must be 4Ω or higher.
(Australia, Singapore and General models:)
The impedance of each speaker must be 6Ω or higher.
Main: If you use one pair of main speakers, the impedance of each speaker must be 4Ω or higher.
If you use two pairs of main speakers, the impedance of each speaker must be 8Ω or higher.
Front effect:
The impedance of each speaker must be 6Ω or higher.
(Lower position)
Center: If you use one center speaker, the impedance of the speaker must be 8Ω or higher.
If you use two center speakers, the impedance of each speaker must be 4Ω or higher.
Rear: The impedance of each speaker must be 8Ω or higher.
Main: If you use one pair of main speakers, the impedance of each speaker must be 8Ω or higher.
(Except Canada model:)
If you use two pairs of main speakers, the impedance of each speaker must be 16Ω or higher.
Front effect:
The impedance of each speaker must be 8Ω or higher.
34