1Antenna Connection Terminals

Connect the included indoor FM antenna to the FM ANT terminal and connect the included AM loop antenna to the AM ANT and GND terminals. To heighten safety and reduce interference, connect the GND terminal to a good earth ground. For improving reception quality, you can connect outdoor FM and/or AM antenna to these terminals (See pages 27 to 29 for details.)

2FREQUENCY STEP Switch (General Model only)

Because the interstation frequency spacing differs in different areas, set this switch to the position suitable for the frequency spacing in your area.

Before sliding this switch, disconnect the AC power plug of this unit from the AC outlet.

3AUDIO SIGNAL Connection Jacks (for Audio Source Equipment)

Connect the inputs and/or outputs of your audio equipment.

4AUDIO/VIDEO SIGNAL Connection Jacks (for Video Source Equipment)

Connect the audio and video inputs and/or outputs of your video equipment. In place of the VIDEO jacks, the S VIDEO jacks can be used for higher resolution and improved picture quality if your VCR, monitor, etc. are equipped with S-VIDEO connectors.

5CENTER OUTPUT Jacks

Center-channel line outputs. Can be connected to input jack(s) of one or two external power amplifier(s) to drive the center speaker(s).

6CENTER SPEAKERS Terminals

When using the built-in center-channel amplifier, connect one or two center speakers here.

7Center Speaker Switch

Set to “C + D” when using two center speakers, or to “C OR D” when using only one center speaker.

8FRONT EFFECT SPEAKERS Terminals

When using the built-in front effect-channel amplifier, connect the front effect speakers here.

9REAR SPEAKERS Terminals

When using the built-in rear-channel amplifier, connect the rear speakers here.

0VOLTAGE SELECTOR (General Model only)

Be sure to set to the line voltage in your area before applying power. Consult your dealer if unsure of the correct setting.

AGND Terminal

Connects the ground wire of the turntable to produce minimum hum. In some cases, however, better results may be obtained with the ground wire disconnected.

BPCM/ DIGITAL IN (COAXIAL and OPTICAL) jacks

Can be connected with audio/video units that have a coaxial or optical digital output jack. Connect a unit that is connected to the DVD/LD AUDIO/VIDEO SIGNAL connection jacks to the DVD/LD COAXIAL or OPTICAL jack.

Connect a unit that is connected to the TV/DBS AUDIO/VIDEO SIGNAL connection jacks to the TV/DBS COAXIAL jack.

*If, for example, your LD player has an AC-3 RF output jack and no digital output jack for AC-3 discrete audio signals, connect the AC-3 RF output jack to the DVD/LD COAXIAL or OPTICAL jack of this unit by way of an RF demodulator (separate purchase).

English

19