Yamaha CRUISING IN, OTHER CONDITIONS, CRUISING IN SALT WATER, CRUISING IN TURBID WATER, PROCEDURE FOR TILTING DOWN

E

4)Once the engine is supported with the tilt-support lever, push the power trim/tilt switch DOWN to retract the trim rods.

cC

Be sure to retract the trim rods completely during mooring. This protects the rods

from marine growths and corrosion

411014 which could damage the power trim/tilt mechanism.

PROCEDURE FOR TILTING DOWN

Power trim and tilt

1)Push the power trim and tilt switch “UP” until the engine is supported by the tilt rod.

2)Release the tilt-support lever.

3)Push the power trim and tilt switch

411021	“DN” (Down) to lower the engine to
	the desired position.

EMH60010

CRUISING INOTHER CONDITIONSCRUISING IN SALT WATER

After operating in salt water, wash out the cooling-water passages with fresh water to prevent them from becoming clogged- up with salt deposits.

NOTE:

Refer to cooling system flushing instructions in STORING AND TRANSPORTING OUTBOARD MOTOR.

CRUISING IN TURBID WATER

It is strongly recommended that the optional chromium-plated water-pump kit be installed if the outboard is to be used in turbid (muddy) water conditions.

3-24