E

6 345

12

602041

602053

[How to remove propeller]

1)Using the pliers provided, straighten the cotter-pin and pull it out.

2)Remove the propeller nut.

3)Remove the propeller.

1 Thrust washer

4 Washer

2 Propeller

5 Propeller nut

3 Spacer

6 Cotter pin

[How to install propeller]

1)Apply Yamaha Marine grease A or Marine grease (water-resistant grease) to the propeller-shaft.

2)Slide the propeller over the propeller- shaft.

cC

Be sure to install the thrust washer before installing propeller, otherwise, lower case and propeller boss may be damaged.

3)Tighten the propeller nut to the specified torque.

Tightening torque:

Refer to “SPECIFICATIONS”, Page 4-1.

4)Align the propeller nut with the propeller shaft hole. Insert a new cotter pin in the hole and bend the cotter pin ends.

NOTE:

When the propeller nut does not align with the propeller shaft hole after tightening to the specified torque, then tighten it more to align the hole.

cC

Be sure to use a new cotter pin and bend the ends over securely. Otherwise, the propeller could come off during operation and be lost.

4-22