Connecting the FM and AM antennas

An indoor FM antenna and an AM loop antenna are supplied with this unit. Connect these antennas properly to the respective jacks.

Connections

Connecting the power cable

After all connections are complete, plug the AC power cable of this unit into an AC wall outlet.

To the AC wall outlet

Indoor FM antenna

DOCK

COMPONENT

VIDEO

PR

PB

VIDEO

Y

Outdoor AM antenna

 

AM loop

Connect a 5 to 10 m (16

antenna

to 33 ft) vinyl-covered

 

 

wire, and extend it

 

 

outdoors (use the AM

 

 

loop antenna together

 

 

with this antenna).

 

 

 

 

(BD/DVD)

HDMI 2

HDMI 3

HDMI OUT

 

HDMI 1

ANTENNA

COMPONENT

 

F

 

 

 

 

 

 

VIDEO

 

 

UNBAL.

 

 

 

 

 

 

PR

 

 

FM

GND AM

PB

 

 

 

 

 

 

 

 

 

VIDEO

 

 

 

Y

 

 

 

 

MONITOR OUT

 

Power cable

PREPARATION

Ground (GND terminal)

The GND terminal is not for earth grounding.

To reduce noises, connect a ground bar or a vinyl-covered wire with a copper plate at its tip, and place it in the moist ground.

y

•The supplied antennas are normally sensitive enough to obtain good reception.

•Position the AM loop antenna away from this unit.

•If you cannot get good reception, we recommend that you use an outdoor antenna. For more details, consult the nearest authorized Yamaha dealer or service center.

•Always use the AM loop antenna even when the outdoor antenna is connected.

Assembling the AM loop antennaConnecting the AM loop antenna

The wires of the AM loop antenna have no polarity. You can connect either wire to the AM terminal and the other to the GND terminal.

Turning this unit on and off

1Press ASTANDBY/ON on the front panel (or fPOWER on the remote control) to turn on this unit.

2Press ASTANDBY/ON (or fPOWER) again to turn off this unit (standby mode).

y

•The unit needs a few seconds until ready to play back.

•You can also turn on this unit by pressing ISCENE (or kSCENE).

•This unit consumes a small amount of electricity even in the standby mode. We recommend disconnecting the power cable from the AC wall outlet.

Caution

Do not unplug this unit while it is turned on. Doing so may damage this unit or cause the settings of this unit to be saved incorrectly.

Press and hold

 

Insert

Release

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

English

17 En