Flat
This adjusts each speaker to obtain the same characteristics. Select this if your speakers have similar qualities.
Front
This adjusts each speaker to obtain the same characteristics as the front left and right speakers. Select this if your front left and right speakers have significantly better qualities than the other speakers.
5Press nCursor nto select “Start” and then press nENTER to start the setup procedure.
A countdown starts and a measurement starts in 10 seconds. A loud test tone is output during measurement.
Notes
•During the automatic setup procedure, do not perform any operation on this unit.
•Press nCursor kto cancel the automatic setup procedure.
Measurement takes about 3 minutes. To obtain precise results, stay where you will not disturb the measurement, such as to the side of or behind the speakers or outside the room.
When measurement is successfully completed, “YPAO Complete” appears on the front panel display and the results appear on the monitor.
1 AutoSetup
RESULT
SP:3/4/0.1
DIST:8.0/8.5ft
. >Set Cancel
[p]/[]:Select
[ENTER]:Finish
SP
Displays the number of speakers connected to this unit in the following order:
Total of Front and Center/Total of Surround and Surround Back/Subwoofer
DIST
Displays the speaker distance from the listening position in the following order:
Closest speaker distance/Farthest speaker distance
LVL
Displays the speaker output levels in the following order: Lowest speaker output level/Highest speaker output level
Notes
•If “ERROR” appears on the video monitor during “Auto Setup,” measurement is canceled and the type of error is displayed. For details, see “When an error message is displayed during measurement” (page 20).
•If problems occur during measurement, “WARNING (XX)” (xx indicates the number of warning) appears above “RESULT” (see page 20).
Optimizing the speaker setting for your listening room (YPAO)
6Press nENTER to confirm the settings.The speaker characteristics are adjusted according to measurement results.
To cancel the operation, press nCursor l/ hto select “Cancel” and press nENTER.
When the following screen appears, remove the optimizer microphone. “Auto Setup” is now complete.
1 AutoSetup
AUTOSETUPComplete
DisconnectMicrophone
PRESS[ENTER]
[SETUP]:Exit
The optimizer microphone is sensitive to heat. Store it in a cool place and away from direct sunlight after measurement. Do not leave it in a place where it will be subjected to high temperatures such on an AV component.
y
•If you do not want to apply the measurement results, select “Cancel.”
•Perform “Auto Setup” again if you change the number or positions of speakers.
•If you press nENTER before removing the optimizer microphone, “1 Auto Setup” of “Speaker Setup” in the setup menu (see page 39) is displayed.
PREPARATION
English