Troubleshooting
Remote control
Problem | Cause | Remedy | See | |
page | ||||
|
|
| ||
|
|
|
| |
The remote control | Wrong distance or angle. | The remote control will function within a maximum | ||
does not work or |
| range of 6 m (20 ft) and no more than 30 degrees |
| |
function properly. |
| offaxis from the front panel. |
| |
|
|
|
| |
| Direct sunlight or lighting (from an | Adjust the lighting angle or reposition this unit. | — | |
| inverter type of fluorescent lamp, strobe |
|
| |
| light, etc.) is striking the remote control |
|
| |
| sensor of this unit. |
|
| |
|
|
|
| |
| The batteries are weak. | Replace all batteries. | ||
|
|
|
| |
| The remote control ID of the remote | Match the remote control ID of this unit and the | ||
| control and this unit do not match. | remote control. |
| |
|
|
|
| |
| The remote control code is not correctly | Set the remote control code correctly using “List of | ||
| set. | remote control codes” at the end of this manual. |
| |
|
|
|
| |
|
| Try setting another code of the same manufacturer | ||
|
| using “List of remote control codes” at the end of this |
| |
|
| manual. |
| |
|
|
|
| |
|
| If this unit does not work when you press nCursor, | — | |
|
| do the following. |
|
When the key does not work during DVD disc menu operation: press the gInput selection keys on the remote control again.
When the key does not work during OPTION menu/ SETUP menu operation: press the key applicable for the current menu operation again.
Even if the remote control code is correctly set, there are some models that do not respond to the remote control.
iPod™
Note
•In case of a transmission error without a status message appearing on the front panel display and the OSD, check the connection of your iPod (see page 16).
Problem | Cause | Remedy | See | |
page | ||||
|
|
| ||
|
|
|
| |
Loading... | This unit is in the middle of recognizing |
|
| |
| the connection with your iPod. |
|
| |
|
|
|
| |
| This unit is in the middle of acquiring |
|
| |
| song lists from your iPod. |
|
| |
|
|
|
| |
Connect error | There is a problem with the signal path | Turn off this unit and reconnect the Yamaha iPod | ||
| from your iPod to this unit. | universal dock to the DOCK terminal of this unit. |
| |
|
|
|
| |
|
| Remove your iPod in the Yamaha iPod universal dock | ||
|
| and then place it back in the dock. |
| |
|
|
|
|
Unknown iPod | The iPod being used is not supported by |
| this unit. |
This unit supports iPod Touch, iPod (Click Wheel), | — |
iPod nano and iPod mini. |
|
iPod Connected Your iPod is properly placed in the Yamaha iPod universal dock.