Advanced setup
In the advanced setup, you can set basic operations of this unit, such as on and off of a
1Set this unit to the standby mode.
2Press ASTANDBY/ON while pressing and holding LSTRAIGHT on the front panel.
The advanced setup menu appears on the front panel display.
ADVANCEDSETUP
3Press KPROGRAM l/ hrepeatedly to select the parameter you want to change.
The default setting are marked with “*.” y
•Set values are placed in XXX of the following parameters on an actual display screen.
SP IMP. -XXX
Choices: 6 MIN/8 MIN*
Selects output impedance of this unit according to connected speakers.
REMOTE ID -XXX
Choices: ID1*/ID2
Sets a remote control ID. When using multiple Yamaha AV receivers, you can operate them with a single remote control by setting the receiver IDs to the same setting.
BI AMP - XXX
Choices: ON/OFF*
Switches on and off of
MON.CHK - XXXX
Choices: YES*/SKIP
Adds upscaling limitation on output signals to a video monitor connected to this unit via the HDMI OUT jack.
INIT-XXXXXXXXX
Choices: DSP PARAM/VIDEO/ALL/CANCEL
Initializes various settings stored in this unit. You can select an initialization method from the following.
DSP PARAM: All parameters of sound field
| programs |
VIDEO: | Video conversion settings (resolution/ |
| aspect) in the setup menu and the OSD |
| display position |
ALL: | Reset this unit to initial factory |
| settings |
CANCEL: | Cancellation of initialization |
4Press LSTRAIGHT a few times to select the value you want to change.
The value selected here becomes effective when this unit is turned on the next time. You can change multiple settings by repeating steps 3 and 4.
5Press ASTANDBY/ON, turns off this system, and press ASTANDBY/ON again.
The value set in step 3 becomes effective, and this unit turns on. When you select initialization in step 3, the initialization is performed.
Setting a remote control ID
Two IDs are provided for the remote control of this unit. If another Yamaha amplifier is in the same room, setting a different remote control ID to this unit prevents unwanted operation of the other amplifier.
ID1 is set for both remote control and amplifier by default. When you change the remote control ID, display “Advance Setup” (see the previous section) and change the ID for the amplifier too.
1Press cCODE SET on the remote control using a pointed object such as the tip of a ballpoint pen.
bTRANSMIT blinks twice.
2Press lSETUP on the remote control.
3Enter the desired remote control ID code.
To switch to ID1:
Enter “5019” using sNumeric keys. To switch to ID2:
Enter “5020” using sNumeric keys. Once the remote control code is registered, bTRANSMIT blinks twice.
If it fails, bTRANSMIT blinks six times. Repeat from step 1.
y
•Initializing the remote control code (see page 44) returns it to ID1.
OPERATION | ADVANCED |
|
|
English