Initial settings
■ AUTO SETUP via setup menu
1 Place the IntelliBeam microphone and press 
SETUP key.
2 Press 
U / V to select “AUTO SETUP” and then press 
ENTER key.
3 Press 
U/ V to select one of the items
below and then press ENTER key.
Select Item:
“BEAM+SOUND OPTIMIZE” (Beam optimization and sound optimization)
It is recommended that you should select this optimization feature, if you make settings for the first time.
This menu takes about three minutes.
“BEAM OPTIMIZE ONLY”(Beam optimization only)
Use to optimize the beam angle so that the parameter best matches your listening environment.
This menu takes about one minute.
“SOUND OPTIMIZE ONLY”(Sound optimization only)
Use to optimize the beam delay, volume, and quality so that the parameters best match your listening environment. You must optimize the beam angle with “BEAM OPTIMIZE ONLY” before starting “SOUND OPTIMIZE ONLY”. It is recommended that you should select this optimization feature in the following cases:
• If you have opened or closed the curtains in your listening room before using this unit
• If you have manually set the beam angle. This menu takes about two minutes.
4 Connect the IntelliBeam microphone to this unit after “AUTO SETUP (PREPARATION & CHECK)” screen is displayed.
For the details on installing and connecting IntelliBeam microphone, refer to “Installing the IntelliBeam microphone (☞p. 17)”.
Note
The best setting may not be done if you are in the room. Prepare to leave the room in 10 seconds after pressing 
ENTER in step 4.