Initial settings

The screen below is displayed after connecting IntelliBeam microphone to the unit. 1) 2)

AUTO SETUP

(PREPARATION & CHECK) Please connect the MIC. Please place the MIC at least 1.8m/6ft away from SoundPro- jector. The MIC should be set at ear level when seated. Measurement takes about 3min. After [ENTER] is pressed, please leave the room.

[ENTER]:Start [RETURN]:Cancel

5 Press ENTER key to confirm the results. 5)

The measurement result is saved.

AUTO SETUP COMPLETE

Please remove the MIC from Sound Projector

and the listening position.

PREPARATION

 

SETTINGS INITIAL

CONNECTION/

Note

 

6

Remove the IntelliBeam microphone.

The best setting may not be done if you are in the room. Prepare to

 

leave the room in 10 seconds after pressing ENTER in step 4.

 

Press

ENTER key to start the AUTO

 

Initial screen appears. 6)

 

Keep the IntelliBeam microphone in a safe place.

4 SETUP procedure and then leave the room

 

 

within 10 seconds. 3)

The setup screen automatically changes during the AUTO

SETUP procedure.

PLAYBACK

AUTO SETUP START

Will begin in 10 sec.

Please leave the room.

---------

[RETURN]:Cancel

(After 3 min.)

The measurement results are stored in the internal memory of this unit until you run the AUTO SETUP procedure again or configure the settings manually. You can save the several measurement result using memory setting function (☞p. 22).

SETTINGS

XXXXXXXXSHOW RESULTXXXXXXXXXX

MEASUREMENT COMPLETE.

BEAM MODE :5Beam/Plus2 SUBWOOFER :Yes

[ENTER]:Save set-up. [RETURN]:Do not save set-up.

TROUBLESHOOTING

If AUTO SETUP procedure is complete, this unit rings the chimes. 4)

APPENDIX

4)y

•If an error occurs, an error buzzer sounds and an error message is displayed. For details on error messages, see “Error messages for AUTO SETUP” (☞p. 21).

•If “ENVIRONMENT CHECK:Failure” is displayed, refer to “Error messages for AUTO SETUP” (☞p. 21), press RETURN key, and then run the AUTO SETUP procedure again.

•Depending on the environment of your listening room, the beam angles of front right and left and surround left and right may be set to the same value even if “BEAM MODE :5 Beam” is displayed as a result.

5)y

If you do not want to reflect the results, press RETURN key.

6)y

When AUTO SETUP is performed from SETUP MENU, menu selection screen of SETUP MENU appears.

19 En