Installation and Connection
■Adjust the height of center unit
In case that the center unit straddles the stands of your TV, turning the stands to left makes the unit higher. Confirm the graduation of each stand to make each stand the same height. Adjust the graduation in the range from 0 to 10.
Adjustable range: 28.5mm to 38.5mm
The graduation
■Remove the center unit legs
When the center unit hides the remote control sensor or signal transmitter for 3D glasses of your TV, turn the center unit over, remove the legs, and use supplied pads as shown below.
1Turn the leg furthermore to the left.
2Remove the outside part of the leg.
3Push the whole leg to the center of the bottom as shown in the illustration while laying the hook to the same direction, and then remove the inside part of the leg.
4Attach the 4
■When the center unit hides the remote control sensor of your TV
The unit receives the signal from the remote control of your TV in front, and transmits to your TV by IR Flasher (supplied). Remove the backing paper on the tip of LED part of IR Flasher, and attach it to the remote control sensor of your TV or the area close to the remote control sensor of your TV on the rear panel of center unit as shown. Connect the plug to the IR output jack of the unit.
Remote control sensor of your TV
IR Flasher (supplied)
Notes
•When using IR Flasher, direct the remote control of your TV to the center unit.
•This function is valid even in the standby mode.
•This function may not activate with some TVs.
Attach the stands to the subwoofer
Install the subwoofer with the supplied stands. Attach the supplied stands with the dowels to the subwoofer. Changing the position of the stands enables both horizontal placement and vertical placement. Horizontal placement is convenient for installing the center of a rack, and vertical placement is convenient for installing the side of a rack.
Horizontal placement | Vertical |
| placement |