Initial settings
Using AUTO SETUP (IntelliBeam)
Notes
• It is normal for loud test tones to be output during the AUTO SETUP procedure. Make sure that there are no children around in the listening room while the AUTO SETUP procedure is in progress.
• Make sure that your listening room is as quiet as possible. For accurate measurement, turn off air conditioner or other devices that make noises.
• If there are curtains in your listening room, we recommend following the procedure below.
1 Open the curtains to improve sound reflection.
2 Run “BEAM OPTIMIZE ONLY”.
3 Close the curtains.
4 Run “SOUND OPTIMIZE ONLY”.
1 Turn the unit and your TV on.2 Switch TV’s input to “VIDEO INPUT 1 (example)”.3 Connect the supplied IntelliBeam microphone to the INTELLIBEAM jack.IntelliBeam microphone
1)y
When pressing 
RETURN key displays the setup menu
Press 
SETUP key repeatedly and display the menu screen again, then select: “AUTO SETUP” “BEAM+SOUND OPTIMIZE”.
When the screen is not displayed
Confirm the case below.
–The input jack of your TV and the video output jack of the unit are connected.
–The input of your TV is set to “VIDEO INPUT 1 (example)”.
2)y
“BEAM+SOUND OPTIMIZE” is selected automatically. When you perform “BEAM OPTIMIZE ONLY” or “SOUND OPTIMIZE ONLY” only, refer to “AUTO SETUP via setup menu (☞p. 20)”.
3)y
•Wait outside the room during the AUTO SETUP procedure.
•The AUTO SETUP procedure takes about 3 minutes.
•To cancel the AUTO SETUP procedure after it is started, press
RETURN key.