Yamaha YSP-2200BL 21 En, ■Error messages for AUTO SETUP

Initial settings

If an error message is displayed on your TV, check the error message list to solve the problem and then follow the procedure below.

[ERROR E-1]: Press ENTER key to run the AUTO SETUP procedure again. Or press Z key to continue the measurement.

[ERROR E-7], [ERROR E-9]: Press key to turn this unit to standby mode, then run AUTO SETUP procedure again after turning this unit on.

Other errors: Press RETURN key to cancel the operation and then run the AUTO SETUP procedure again.

If the problem is difficult to be solved, configure the settings manually in “SETUP MENU” (☞p. 36).

ERROR E-1: Please test in quieter environment.

Cause	Remedy

There is too much unwanted	Make sure that your listening
noise in your listening room.	room is as quiet as possible. You
	may want to choose certain hours
	during the day when there is not
	much noise coming from outside.

ERROR E-2: No MIC detected. Please check MIC connection and re-try.

Cause	Remedy

The IntelliBeam microphone is	Connect the IntelliBeam
not connected to this unit or	microphone to this unit firmly.
disconnected during the AUTO
SETUP procedure.

ERROR E-6: Volume level is lower than expected. Please check MIC position/connection and re-try.

Cause	Remedy

The IntelliBeam microphone	Make sure that the IntelliBeam
cannot collect the sound	microphone is firmly connected
produced by this unit because the	to this unit and placed in a proper
sound output level is too low.	location. If the problem persists,
	contact the nearest
	authorized Yamaha service
	center for assistance.

ERROR E-7: Unexpected error happened. Please turn off and re-try.

ERROR E-9: Turn off and check the connection with subwoofer.

PREPARATION
SETTINGS INITIAL	CONNECTION/

PLAYBACK

SETTINGS

ERROR E-3: Unexpected control is detected. Please re-try.

Cause	Remedy

Some other operations were	Do not perform any other
performed on this unit while the	operations while the AUTO
AUTO SETUP procedure was in	SETUP procedure is in progress.
progress.

ERROR E-4: Please check MIC position. MIC should be set in front of the Sound Projector and re-try.

Cause	Remedy

The IntelliBeam microphone is	Make sure that the IntelliBeam
not placed in front of this unit.	microphone is installed in front
	of this unit.

ERROR E-5: Please check MIC position. MIC should be set above 1.8m/6.0ft and re-try.

Cause	Remedy

The IntelliBeam microphone is	Make sure that the IntelliBeam
not placed in the right distance	microphone is installed more
from this unit.	than 1.8 m (6.0 ft) from the front
	of this unit and within 1 m (3.3
	ft) from the center height of this
	unit.

TROUBLESHOOTING

APPENDIX