Setup menu

Manual setup

Use this menu to manually adjust the parameters related to the sound beam output. To fine-adjust parameters configured by AUTO SETUP, use “BEAM ADJUSTMENT” and “IMAGE LOCATION”.

When this unit is installed at the corner of the room, specify the width of length of the listening room.

 

Setting parameters

 

 

 

 

 

 

 

 

 

 

3

In “SETTING PARAMETERS 3/3”,

MANUAL SETUP  SETTING PARAMETERS

configure the distance settings.

Use to set the position of this unit in your listening room and the

 

 

 

 

distance of this unit from the listening position. 1) 2)

1 In “SETTING PARAMETERS 1/3”, configure “INSTALLED POSITION”.

Select the installed position of this unit. 3)

Selectable item: FLAT TO WALL* (parallel to wall), ANGLE TO WALL OR CORNER (angle to wall or corner)

FLAT TO WALL

 

ANGLE TO WALL OR

 

 

CORNER

 

 

 

 

 

 

Specify the distance between the listening position and this unit. When this unit is installed parallel to wall, you also need to specify the distance between the listening position and left wall.

Control range (from this unit): 1.8 m to 9.0 m (6.0 ft to 30.0 ft)

Control range (from left wall): 0.6 m to 11.4 m (2.0 ft to 38.0 ft)

FLAT TO WALL

0.6 to 11.4 m

(2.0 to 38.0 ft)

1.8to 9.0 m (6.0 to 30.0 ft)

2 In “SETTING PARAMETERS 2/3”, configure the listening room settings.

Specify the length and width of the listening room.

Control range: 2.0 m to 12.0 m (6.5 ft to 40.0 ft)

When this unit is installed parallel to wall, specify the width of the listening room and the distance between this unit and rear wall.

1)y

If you make adjustments in “SETTING PARAMETERS”, the “BEAM ADJUSTMENT” parameters are automatically adjusted.

2)y

If you make adjustments in “SETTING PARAMETERS”, the beam optimization settings made in the AUTO SETUP procedure will be lost.

3)y

If you change this setting, “Surround mode” setting changes automatically (☞p. 29).

38 En