Restore Factory Default Settings, Reboot | Z-Com ZMAX-8210-E

The file name shall be mercury.cfg.

Restore Factory Default Settings

The ZMAX-8210 provides two ways to restore the default factory settings.

Restore the factory default settings via web:

From the “Restore Factory Default Settings”, clicking “ Restore ” will restore your

ZMAX-8210 default settings.

Restore the factory default settings via “Restore Button”.

When the ZMAX-8210 power adapter is connected to this device, press “Default Button”for

about over10seconds. The“Default Button”is shown as below:

Hardware

Default Button

Figure 24 ZMAX-8210 Default Button

Reboot

The ZMAX-8210 supports PoE supply. You can restore web-based management to reboot this CPE. Enabling “Yes” can reboot it.

Figure 25 Reboot

SSH

The ZMAX-8210 provides SSH management. It is recommended that Putty is your right option to access this device’s management.

Open by double clicking Putty

Enter 192.168.1.1 in the “Host Name” field and “Protocol”.

Chapter 5 Management

- 24 -

Image 30

Z-Com ZMAX-8210-E, ZMAX-8210-I user manual Restore Factory Default Settings, Reboot

Contents

Page Copyright Bold Indicates the function, important words, and so on Troubleshooting ManagementPage ZMAX-8210 Page Introduction IntroductionAppearance Key Features Build Typical Infrastructure Wireless Point-to-Point Outdoors Wireless Point-to-multipoint Outdoors Typical Case Hardware Installation Basic InstallationPackage Content System Requirement Ground Antenna Installation How to Login Your ZMAX-8210 via WEB Browser Basic SettingsDefault Factory Settings ZMAX-8210 Default Factory Settings Safety Alert Device Name ZMAX-8210 General Information Bridge and Router Mode IP Address Wireless Parameters ZMAX-8210 Wireless Parameters Create a Link between the ZMAX-8210 and WiMAX Base Station Build the Infrastructure with WiMAX Base Station Basic Settings Advanced Configuration Router Mode Wireless Router Mode Any IP Dhcp Server Time Server Http Redirect Typical Http Redirect Case Http Redirect Management View the ZMAX-8210 Basic InformationView Statistics Information Password Upgrade Firmware Backup and Retrieve Chapter Retrieve and Backup Settings Restore Factory Default Settings Reboot Putty Settings SSH Settings Management Why my PC fails to access the internet? TroubleshootingFrequently Asked Question FAQ Why I fail to configure my ZMAX-8210？ Refer to Restore Factory Default Settings How I could know my PC has connected to the ZMAX-8210? ZMAX-8210 Ping Appendix a Specifications ZMAX-8210-I Spec QAM 3/4 64QAM 3/4 Interface ZMAX-8210-E Spec Module ZMAX-8210-E Secure WEB Management Yes Interface Appendix B Technical Terms Technical Terms Device and other devices Appendix C Ascii Ascii Appendix C Ascii Appendix D SSH Settings TrapServer Address Read Snmp Readcommunity Community Appendix D SSH Settings