Alvarion SW VERSION 5.1 Configuring Basic Parameters, Initial Configuration, Essid ESSID1

Chapter 3 - Commissioning

3.1Configuring Basic Parameters

3.1.1Initial Configuration

After completing the installation process, as described in the preceding chapter, the basic parameters must be configured to ensure that the unit operates correctly. After the basic parameters have been configured, additional parameters can be remotely configured via the Ethernet port or the wireless link using Telnet or SNMP management, or by loading a configuration file.

Refer to section 4.1 for information on how to access the Monitor program using Telnet and how to use it.

The Basic Configuration menu includes all the parameters necessary for the initial installation and operation of Subscriber and Access Units. In many installations, most of these parameters should not be changed from their default values. The basic parameters and their default values are listed in Table 3-1.

Refer to Chapter 4 for detailed information on the applicable parameters.

	Table 3-1: Basic Parameters
	Parameter	Default Value	Comment
	Ethernet Port Negotiation Mode	Auto Negotiation
	(in Unit Control Parameters)
	IP Address	10.0.0.1
	Subnet Mask	255.0.0.0
	Default Gateway Address	0.0.0.0
	DHCP Options	Disable
	Access to DHCP	AU: From Ethernet Only
		SU: From Wireless Only
	ESSID	ESSID1
	Country Code Select	Depends on factory	Applicable only for 5.4
		configuration	and 5.8 GHz units. See
			3.1.2 below.
	Sub-Band Select (AU)	1	Applicable only if more
			than one Sub-Band is
			available
	Frequency (AU)	The lowest frequency in
		the selected Sub-Band
70		BreezeACCESS VL System Manual