Chapter 4 - Operation and Administration
2.When operating at 5055 MHz, the Transmit Power parameter in the AU should not be set to a value above 13 dBm. The Maximum Transmit power of the SU should not be set to a value above 10 dBm.
This requirement, although not indicated in the certification document, is needed following the tests performed in the certification lab.
NOTE 2 (FCC 5.3 GHZ, 10 MHz Bandwidth)
For full compliance with FCC regulation of units with HW rev C using a 10 MHz bandwidth, if you wish to include frequency channel 5265 MHz in the set of frequencies to be used, then the Transmit Power parameter in the AU, and the Maximum Tx Power parameter in the SUs, should not be set to a value above “25- Antenna Gain”. If there is a need to use a higher value for these parameters, this frequency should not be used.
NOTE 3 (FCC 5.3 GHZ, 20 MHz Bandwidth)
For full compliance with FCC regulations, the following requirements should be followed in units using a 20 MHz bandwidth:
1.In units HW Revision B, if you wish to include frequency channel 5270 MHz in the set of frequencies to be used, then the Transmit Power parameter in the AU, and the Maximum Tx Power parameter in the SUs, should not be set to a value above
2.In units with HW Revision C, if you wish to include one or more of frequency channels 5270, 5275 and 5330 MHz in the set of frequencies to be used, then the Transmit Power parameter in the AU, and the Maximum Tx Power parameter in the SUs, should not be set to a value above
4.2.6.2.4.3DFS Parameters
The DFS Parameters submenu is available only if DFS is supported by the current
4.2.6.2.4.3.1DFS Required by Regulations
The DFS Required by Regulations option enables defining whether DFS should be used for compliance with applicable local regulations. The options are Yes or No. Selection of the No option will disable the radar detection and dynamic frequency selection mechanism.
The default is Yes.
BreezeACCESS VL System Manual
134
