Chapter 2 - Installation
2.4Installing the Universal IDU Indoor Unit
The unit can be placed on a desktop or a shelf. Alternatively, it may be
Figure 2-13: IDU PS 1073 Front Panel
The RADIO connector and RESET button are located on the front panel, the ETHERNET connector is located on the side panel and LEDs are located on the top panel.
CAUTION
Do not connect the data equipment to the RADIO port. The RADIO port supplies DC power to the ODU, and this may harm other equipment connected to it.
To install the IDU:
1Connect the
2Connect the power cord to the unit's AC socket, located on the rear panel. Connect the other end of the power cord to the AC mains. The unit can operate with AC mains of
NOTE
The color codes of the power cable are as follows:
Brown | Phase | ~ |
Blue | Neutral | 0 |
Yellow/Green | Ground |
|
3Verify that the POWER LED is lit, indicating that power is supplied to the unit.
4Configure the basic parameters as described in section 3.1.
5Connect the 10/100 BaseT ETHERNET connector to the network. The cable connection should be a straight Ethernet if connecting the indoor unit to a hub/switch and a crossed cable if connecting it directly to a PC Network Interface Card (NIC).
52
