Install ZX Station
FINAL ADJUSTMENTS
Slide the ZX Station partially out.
Lift the ZX Station while tightening the pancakehead Phillips screws in the front slider bracket.
Go to the rear of the cabinet to tighten the slider rail screws. If there is not enough room to work at the back of the cabinet, the ZX Station may need to be removed to tighten the rail screws.
The ZX Station should now slide in and out smoothly. If not, repeat these steps.
The ZX Station should slide in and out easily. If not, repeat these adjustment steps.
SECURING ZX STATION IN CABINET FRAME
Use four ovalhead Phillips screws, stainless steel and nylon recep- tacle washers to secure the front panel of the ZX Station to the front of the cabinet frame.
11
Document#
