INSTALLATION INSTRUCTIONS
FITTING INTO THE SPACE BETWEEN CABINETS
IMPORTANT: Ensure that the oven is switched off at the wall before any further work is carried out.
Ensure the appliance is in front of the cabinet. |
See Fig. 13. |
Take out all oven furniture before installation to |
reduce the weight you need to lift. |
To place the appliance into the space between |
cabinetry follow the procedure below: |
N.B. Two people will be required to carry out |
the lifting procedure. |
Warning: Do not attempt to lift this appliance by |
the handle(s). |
Each person should squat either side of the |
appliance. |
Tilt the appliance so that your hands can support |
the underside of the appliance. |
Raise the appliance to the correct height. |
Fig.13
Fig.14
Rest the rear underside of the appliance on the |
mounting brackets while your hands support the |
front. |
The appliance can be pushed fully into the |
space. Take care to avoid fouling the mains |
lead. |
Ensure the appliance is central and level. |
When the appliance is fully housed, screw the |
WORK TOP
HEAT SHEILD
LEVEL WITH
FRONT EDGE
OF WORK
TOP
TOP OVEN
DOOR
stability screws (supplied with the appliance) into |
the underside of the worksurface in the positions |
indicated (see Fig. 14), taking care not to distort |
the trim. It is advisable to turn each screw |
alternatively to avoid damaging the trim. |
Place the heat deflector flush with the edge of the |
worksurface, (see Fig.15) with the cork spacers |
upover (see Fig.16) and screw into position using |
the screws supplied with the appliance. |
Replace the plinth board. |
Switch on the appliance and refer the user to the |
operating instructions. |
Fig.15
Fig.16
58
