2.Push the knob down for 10 seconds and turn it counterclockwise to the maximum position 
.
3.Keep the knob pushed for approximately 10 sec- onds. This will let thermocouple warm up. If not, the gas supply is interrupted.
4.Adjust the flame when it is regular.
If after some tries the burner does not light, check if the crown and its cap are in the correct positions.
1
2
3
1Burner cap
2Burner crown
3Thermocouple
Warning! Do not keep the control knob pushed for more than 15 seconds.
If the burner does not light after 15 seconds, release the control knob, turn it into off position and try to light the burner again after minimum 1 minute.
If the burner accidentally goes out, turn the control knob to the off position and try to light the burner
again after minimum 1 minute.
Turning the burner off
To put the flame out, turn the knob to the symbol 
.
Warning! Always turn the flame down or switch it off before you remove the pans from the burner.
Hob - Helpful hints and tips
Energy savings
•If possible, always put the lids on the pans.
•When the liquid starts to boil, turn down the flame to barely simmer the liquid.
Use pots and pans with bottom applicable to the di- mension of the burner.
Burner | Diameters of cookware |
Rapid | 160 mm - 240 mm |
Burner | Diameters of cookware |
140 mm - 240 mm | |
Auxiliary | 120 mm - 180 mm |
Use cookware with the bottom as thick and flat as possi- ble.
Hob - Care and cleaning
Warning! Refer to "Safety information" chapter.
6
Warning! Switch the appliance off and let it cool down before you clean it.
www.zanussi.com
