Important! When installation is complete, make sure that the seal of each pipe fitting is correct. Use a soapy solution, not a flame!
The gas supply ramp is on the rear side of the control panel.
Warning! Before gas connection disconnect the mains plug from the mains socket or switch off the
fuse in the fuse box. Close the primary valve of the gas supply.
2 |
4
1Gas connection point (only one point is applicable for appliance)
2Gasket
3Adjustable connection
4LPG pipe holder
The appliance is set to default gas, to change the setting choose pipe holder No 4. Always use the
gasket sealing.
Adjustment to different types of gas
Warning! Let only an authorized person do the adjustment to different types of gas.
This appliance is for operation with natural gas. With the correct injectors, you can also operate it
with liquid gas.
Warning! Before replacing the injectors, make sure that the gas knobs are in the off position. Let the
appliance cool off fully. There is a risk of injury.
Injectors replacement
Replace the nozzles when changing the gas type.
1.Remove the pan supports.
2.Remove the caps and crowns of the burner.
3.With a socket spanner 7 remove the injectors and re- place them with the ones which are necessary for the type of gas you use.
4.To assemble the parts, do the same steps in reverse.
5.Replace the rating label (it is near the gas supply pipe) with the one for the new type of gas supply. You can find this label in the package supplied with
the appliance.
If the supply gas pressure is changeable or different from the necessary pressure, you must fit an applicable pres- sure adjuster on the gas supply pipe.
Adjustment of minimum level
To adjust the minimum level of the burners:
1.Light the burner.
2.Turn the knob on the minimum position.
3.Remove the control knob.
4.With a thin screwdriver, adjust the
1
1Minimum adjustment screw
5.Make sure the flame does not go out when you quickly turn the knob from the maximum position to the minimum position.
Oven injector replacement
www.zanussi.com
