Zanussi ZOB 590 Instructions for the Installer, Terminal block, electrolux, installed, Letter L

64electrolux

Instructions for the Installer

Installation and connection must be done in compliance with the regulations in force. Any interventions must be carried out when the appliance is switched off. Only accredited engineers may work on the appliance.

The manufacturer disclaims any liability if the safety measures are not observed.

Connecting to the electrical supply

Before connecting to the electrical supply, please make sure:

-The fuse and the domestic electrical installation must be designed for the max. load of the appliance (see rating plate).

-The domestic electrical installation must be equipped with a proper earth connection in accordance with the regulations in force.

-The socket or the multi-pole off switch must be easy to access after the appliance has been

installed.

This appliance is delivered with an electric supply cable.

A proper plug, according to the electric load speci- fied on the rating plate, must be fitted to the cable. The plug is to be inserted into a suitable wall socket. If you require a direct connection to the electric network (mains), it will be necessary to fit between the appliance and the mains an omnipole switch, with a minimum gap between contacts of 3 mm, suitable for the required load and in compliance with rules in force. The green & yellow ground wire must not be interrupted by the switch and it should be 2-3 cm. longer than the other cables.

The mains cable and plug as supplied are to be connected to a shockproof socket (230 V~, 50 Hz). The shockproof socket must be installed in accordance with the regulations.

64

The following types of mains cable are suitable, taking the necessary rated cross section into ac- count: H07 RN-F, H05 RN-F, H05 RR-F, H05 VV-F, H05 V2V2-F (T90), H05 BB-F.

The connection cable must in any case be laid out so that at no point does it reach 50°C (over room temperature).

After the connection has been carried out, the heat- ing elements must be tested by being operated for about 3 minutes.

Terminal block

The oven is fitted with an easily accessible terminal block which is designed to operate with a single- phase power supply of 230 V.

Letter L -		Live terminal
Letter N-		Neutral terminal
	or E -	Earth terminal