Card
Printer
Solutions
General information
Getting started
Operation
Printing a card
Cleaning
Troubleshooting
Specifications
Appendix A
Appendix B
Appendix C
P420i Plastic Card Printer
C- CARD THICKNESS CONTROL LEVER
This item is operated by the user to prevent more than one card feeding into the printer at the same time and causing a jam.
Open Cover, and adjust lever to correct position.
Repeat for different card thickness.
(Factory setting is for 30mil (0.762mm) card thickness). See diagram below:
Card Thickness:
A - 60mil (1.524mm) to 50mil (1.27mm)
B - 40mil (1.016mm)
C - 30mil (0.762mm)
D - 20mil (0.508mm)
E* - Less than 20 mil (0.508mm)
* Start at lowest position and move lever up to match card thickness.
For other card thickness, start lever at lowest position and move up until cards feed.
D- CARD OUTPUT HOPPER
This item is used for collecting printed cards.
Install Card Output Hopper onto printer by hooking over bottom edge of card exit aperture.
