64Configuration

Control Panel Parameters

Table 12 • Printer Parameters (Page 3 of 24)

Parameter Action/Explanation

Adjust the Tear-Off Position

This parameter establishes the position of the media over the tear-off/peel-off bar after printing.

See Figure 13. Higher numbers move the media out (the tear line moves closer to the leading edge of the next label), and lower numbers move the media in (the tear line moves closer to the edge of the label just printed).

Figure 13 • Tear-Off Position Adjustment

1

2

1Media direction

2Factory-set tear line location at position 00

Default Value: +0

Range: –120 to +120

To change the value shown:

1.Press SELECT to select the parameter.

2.Press PLUS (+) to increase the value. Each press adjusts the tear-off position by four dot rows.

3.Press MINUS (-)to decrease the value. Each press adjusts the tear-off position by four dot rows.

4.Press SELECT to accept any changes and deselect the parameter.

Select Print Mode

This parameter tells the printer how printed labels will be removed. Make sure that you select a print mode that is compatible with your printer and printer options. For information about how the print modes work with different printer options, see Print Modes and Printer Options on page 30.

Default Value: TEAR-OFF

Selections: TEAR-OFF, PEEL-OFF, CUTTER, DELAYED CUT,

LINERLESS-P, LINERLESS-R, REWIND

To change the value shown:

1.Press SELECT to select the parameter.

2.Press PLUS (+) or MINUS (-)to scroll through the options.

3.Press SELECT to accept any changes and deselect the parameter.

79695L-001 Rev. A

ZM400/ZM600 User Guide

3/27/07