82Configuration

Control Panel Parameters

 

 

Table 12 • Printer Parameters (Page 21 of 24)

 

 

 

 

 

 

 

 

 

 

Parameter

 

 

Action/Explanation

 

 

 

 

 

 

 

 

 

ZPL and XML only

 

 

Set Reprint Mode

 

 

 

 

When reprint mode is enabled, you can reprint the last label printed either

 

 

 

 

 

 

 

 

by issuing the ~PR ZPL command or by pressing MINUS (-)on the control

 

 

 

 

panel.

 

 

 

 

Default Value: DISABLED

 

 

 

 

Selections: ENABLED, DISABLED

 

 

 

 

To change the value shown:

 

 

 

 

 

 

 

 

1.

Press SELECT to select the parameter.

 

 

 

 

2.

Press PLUS (+) or MINUS (-)to toggle between the options.

 

 

 

 

3.

Press SELECT to accept any changes and deselect the parameter.

 

 

 

 

 

 

 

 

 

See next column

 

 

View Sensor Settings

 

 

 

 

These parameters are automatically set during the calibration procedure

 

 

 

 

and should be changed only by a qualified service technician. Refer to the

 

 

 

 

ZPL II Programming Guide for information on these parameters.

 

 

 

 

To skip these parameters:

 

 

 

 

1.

Press PLUS (+) to skip each of the following parameters:

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

79695L-001 Rev. A

ZM400/ZM600 User Guide

3/27/07