Zebra Technologies ZM600, ZM400, ZM400201101L0T Set Maximum Label Length, Figure 14 • Label Length, Table 12 • Printer Parameters (Page 6 of 24)

Configuration 67

Control Panel Parameters

Table 12 • Printer Parameters (Page 6 of 24)

Parameter Action/Explanation

Set Maximum Label Length

This parameter is used during the media portion of the calibration process.

Always set maximum label length to a value that is at least 1.0 in.

(25.4 mm) greater than the actual label length (Figure 14). If the value is set to a smaller value than the label length, the printer assumes that continuous media is loaded, and the printer cannot calibrate.

For example, if the label length is 5.0 inches (126 mm) including the interlabel gap, set the parameter for 6.0 inches (152 mm). If the label length is 7.5 inches (190 mm), set the parameter for 9.0 inches (229 mm).

Figure 14 • Label Length

}2

3 1

1Label length (including interlabel gap)

2Interlabel gap

3Set maximum label length to approximately this value

Default Value: 39.0 inches (988 mm).

Selections: Values are adjustable in one-inch (25.4 mm) increments.

To change the value shown:

1.Press SELECT to select the parameter.

2.Press PLUS (+) or MINUS (-)to change the value shown.

3.Press SELECT to accept any changes and deselect the parameter.

3/27/07 ZM400/ZM600 User Guide 79695L-001 Rev. A