Zebra Technologies ZM600, ZM400, ZM400201101L0T Select ZPL Mode, ZPL and XML only, ZPL and XML only, Set Delimiter Character

			Configuration	79
			Control Panel Parameters
		Table 12 • Printer Parameters (Page 18 of 24)
	Parameter		Action/Explanation
ZPL and XML only			Set Delimiter Character
			The delimiter character is a two-digit hex value used as a parameter place
			marker in ZPL/ZPL II format instructions. See the ZPL Programming
			Guide for more information.
			Note • Do not use the same hex value for the control, format, and
			delimiter character. The printer must see different characters to
			work properly.
			Default Value: 2C ,
			Range: 00 to FF
			To change the value shown:
			1. Press SELECT to select the parameter.
			2. Press MINUS (-)to move to the next digit position.
			3. Press PLUS (+) to increase the value of the digit.
			4. Press SELECT to accept any changes and deselect the parameter.
ZPL and XML only			Select ZPL Mode
			The printer remains in the selected mode until it is changed by this
			parameter or by using a ZPL/ZPL II command. The printer accepts label
			formats written in either ZPL or ZPL II, eliminating the need to rewrite any
			ZPL formats that already exist. See the ZPL Programming Guide for more
			information on the differences between ZPL and ZPL II.
			Default Value: ZPL II
			Range: ZPL II, ZPL

To change the value shown:

1.Press SELECT to select the parameter.

2.Press PLUS (+) or MINUS (-)to toggle between the options.

3.Press SELECT to accept any changes and deselect the parameter.

3/27/07 ZM400/ZM600 User Guide 79695L-001 Rev. A