Configuration 81

Control Panel Parameters

Table 12 • Printer Parameters (Page 20 of 24)

Parameter Action/Explanation

Select Backfeed Sequence

This parameter sets when label backfeed occurs after a label is removed in some print modes. It has no effect in Rewind mode. This setting is superseded by ~JS when received as part of a label format (see the ZPL Programming Guide for more information).

Default Value: DEFAULT (90%)

Selections: DEFAULT, AFTER, OFF, BEFORE, 10%, 20%, 30%, 40%, 50%, 60%, 70%, 80%

To change the value shown:

1.Press SELECT to select the parameter.

2.Press PLUS (+) or MINUS (-)to scroll through the options.

3.Press SELECT to accept any changes and deselect the parameter.

Adjust Label Top Position

This parameter adjusts the print position vertically on the label. Positive numbers adjust the label top position farther down the label (away from the printhead) by the specified number of dots. Negative numbers adjust the position up the label (toward the printhead).

Default Value: +000

Range: –120 to +120 dots

To change the value shown:

1.Press SELECT to select the parameter.

2.Press PLUS (+) to increase the value.

3.Press MINUS (-)to decrease the value.

4.Press SELECT to accept any changes and deselect the parameter.

Adjust Left Position

This parameter adjusts the print position horizontally on the label. Positive numbers adjust printing to the left by the specified number of dots. Negative numbers shift printing to the right.

Default Value: 0000

Range: –9999 to +9999 dots

To change the value shown:

1.Press SELECT to select the parameter.

2.Press MINUS (-)to move the cursor.

3.Press PLUS (+) to change between +/- and to increase the value of the digit. For a negative value, enter the value before changing to the minus sign.

4.Press SELECT to accept any changes and deselect the parameter.

3/27/07

ZM400/ZM600 User Guide

79695L-001 Rev. A