¤
LT2002
QuickSet II Programmer
LT2002 Clone Programmer
As the cloning procedure is being performed, specific steps need to
be done at the indicated times to achieve the desired result. Be sure to do each cloning task as indicated. If a
procedure or step is left out or not
performed correctly, then the TV
setup will be wrong and cloning may not
work. At each step, pay attention to assure
the TV screen shows the proper message(s)
when cloning. If the message indicated does not appear, there is a problem with that step and cloning may not be successful. Cloning is
only possible when the signal source is an Analog channel, not a digital channel.
Optional Installer Remote
You will need an Installer remote control similar to the one shown to the right.
The TV’s clonable features need to be set up before 2-5-5 + Menu is done. This is a critical step.
If the Master TV display panel’s clonable features like: Clock Set, adding channel icons and channel labels, etc. are not done properly, then the cloned TV/STB will all have problems. For example, do not do 2-5-5 + Menu more than once or the TV setup will become corrupted. If you need to start the procedure over, then begin by setting installer item 117 to 001, and pressing Enter to reset the TV to default val- ues in the installer menu. You can do 2-5-4 + Menu mode more than once but this mode is limited to only editing channel icons and channel labels.
Refer to the appropriate section in the Manual for other TV features: Picture, Sound etc.
*Note: Digital Font options are available only after a channel search has been run and when the TV is tuned to an active digital channel with digital captions.
Installer Overview
Following is the Commercial Mode Operation Setup.
HCS5610XX PTC INSTALLER MENU
Operating Installer Menu |
|
| ||
To set up the controls for the TV you will need to know how to enter |
|
|
| |
000 | INSTALLER SEQ | 000 | ||
the TV/STB Installer menu and make changes to the default values | ||||
|
|
| ||
as required. If necessary, familiarize yourself with the TV/STB |
|
| ||
Installer menu and how to make and save changes in the menu. |
|
| ||
| UPN | FPGA 09F1 | ||
| PTC V1.00.000 | CPU V1.01.00 | ||
|
|
|
| |
