Zenith HCS5610 Viewing Equipment Setup, Connect Aux Control IR Output as required of your system

Viewing Equipment Setup

Connect the TV/STB to the display device that will be used to view the signal. An unswitched AC power outlet is specifically provided on the TV/STB to plug the display panel into.

Plasma or LCD Display Panel Setup for use with the TV/STB Commercial Interface Control Box

Connect RS-232C cable. (See previous page.) Connect IR Receiver cable to Remote In port.

Connect the Cable Out jack to the display panel, typically the Antenna (In) jack.

Plug the display panel AC power cord into the convenience AC power outlet provided on the TV/STB.

Plug the TV/STB AC power cord into a stan- dard 120V 60 Hz power outlet.

Once power is applied to the TV/STB, the AC power outlet is active. The LED on the dis- play panel will turn red, indicating that the panel is in standby mode.

Use the user-supplied remote control to turn on the TV/STB.

Antenna

Wall Jack

3.5mm Stereo Plug

with IR Receive

FR Coaxial Wire		Audio
	.	R - L
(75ohm)	....
	........
	.......
	....
	DVI

HCS5610 PTC INSTALLER MENU

000	INSTALLER SEQ		000
UPN 000-000-000-000 FPGA E0F1
PTC V1.00.000		CPU V1.00.00

3.5mm Stereo Plug

Connect Aux Control IR Output as required of your system.

						AC OUT	AC IN
		AUDIO IN	AUDIO OUT		RS-
REMOTE
IN
RJP
INTERFACE	1	2		DIGITAL AUDIO
AUX		DIGITAL	DIGITAL		DISPLAY	MAX 8A 960W	AC 120V~ 60Hz
CONTROL		VIDEO IN	VIDEO OUT	OUT (OPTICAL)	CONTROL

AC Power

Coad

P A G E 1 4