10. Programmable Features
6.Select “On” or “Off” (default), then press
{>}.
7.Press {ih}.
Note:
LWhen the night mode is turned ON, “[N]” is displayed.
LSet the receiving mode to TEL mode.
Setting the start and end time for night mode
1.Press {j/OK}.
2.Select “Handset Setup”, then press {>}.
3.Select “Ringer Setup”, then press {>}.
4.Select “Night Mode”, then press {>}.
5.Select “Start/End”, then press {>}.
6.Enter the desired hour and minute you wish to start this feature by selecting 2 digits for each.
L If you use
7.Enter the desired hour and minute you wish to end this feature by selecting 2 digits for each.
L If you use
8.Press {j/OK}.
9.Press {ih}.
Setting the ring delay for night mode
This setting allows the handset to ring during night mode if the caller waits long enough. After the selected delay time has passed, the handset will ring. If you select “No Ringing”, the handset will not ring during night mode.
1.Press {j/OK}.
2.Select “Handset Setup”, then press {>}.
3.Select “Ringer Setup”, then press {>}.
4.Select “Night Mode”, then press {>}.
5.Select “Ring Delay”, then press {>}.
6.Select “30 sec.”, then press {>}.
7.Press {ih}.
Note:
LWe recommend you select “30 sec.”. This is because the base unit detects an incoming call prior to handset.
Selecting categories to bypass night mode
1.Press {j/OK}.
2.Select “Handset Setup”, then press {>}.
3.Select “Ringer Setup”, then press {>}.
4.Select “Night Mode”, then press {>}.
5.Select “Select Category”, then press
{>}.
6.Press the desired category numbers, then press {j/OK}.
L The selected category number will flash. L To cancel a selected category number,
press the number again. The number will stop flashing.
7.Press {ih}.
10.5.5 Display setup
Selecting the standby mode display
“Base Number”: The current base unit number is displayed.
“Handset Number”: The current handset number is displayed.
“Off” (default): Only the current date and time are displayed.
1.Press {j/OK}.
2.Select “Handset Setup”, then press {>}.
3.Select “Display Setup”, then press {>}.
4.Select “Standby Display”, then press
{>}.
5.Select the desired setting, then press {>}.
6.Press {ih}.
Note:
L If “Base Number” is selected and the current base unit number is 2,
L If “Handset Number” is selected and the current handset number is 2, “[2]” is displayed.
Changing the display language
1.Press {j/OK}.
2.Select “Handset Setup”, then press {>}.
3.Select “Display Setup”, then press {>}.
4.Select “Select Language”, then press
{>}.
5.Select the desired language, then press {>}.
6.Press {ih}.
Note:
LIf you select a language you cannot read, press {ih}, {j/OK}, press {e} 2 times, press {>}, press {v} 2 times, press {>}, press {v}, press {>}, select the desired language, then press {>}. Press {ih}.
76
