10. Programmable Features
“ON” (default): You will hear the friendly reception voice guide,
“OFF”: Deactivates this feature.
Code #53: Turning SMS ON/OFF (KX- FC235AL only)
SMS
=OFF [±]
See page 41 for details.
Code #54: Changing the recording time for your TAM/FAX greeting message
GREETING TIME
=16s [±]
“16s” (default): Maximum recording time is 16 seconds.
“60s”: Maximum recording time is 60 seconds. See page 61 for details.
Code #58: Setting the scan contrast
SCAN CONTRAST
=NORMAL [±]
To send or copy a document with faint or dark writing, set this feature before transmission or copying.
“NORMAL” (default): Used for normal writing.
“LIGHT”: Used for dark writing.
“DARKER”: Used for faint writing.
Code #67: Setting the incoming message monitor
ICM MONITOR
=ON[±]
To hear an incoming message (ICM) from the speaker when the answering device is recording the message.
“ON” (default): You can monitor the incoming message.
“OFF”: Deactivates this feature.
Code #68: Setting the Error Correction Mode (ECM)
ECM SELECTION
=ON[±]
This feature is available when the transmitting/receiving fax machines are ECM compatible.
“ON” (default): If there is an error during fax transmission/reception, the fax machine will support the communication.
“OFF”: Deactivates this feature.
Note:
LYou cannot change the setting when received documents are in memory.
Code #76: Setting the connecting tone
CONNECTING TONE
=ON[±]
If you often have trouble when sending faxes, this feature allows you to hear connecting tones: fax tone, ring back tone and busy tone. You can use these tones to confirm the status of the other party’s machine.
“ON” (default): You will hear connecting tones.
“OFF”: Deactivates this feature.
Note:
LIf the ring back tone continues, the other party’s machine may not be a fax machine or may have run out of paper. Check with the
other party.
LThe connecting tone volume cannot be adjusted.
Code #77: Changing the receiving mode in the auto answer setting
AUTO ANSWER
=TAM/FAX [±]
“TAM/FAX” (default): Telephone Answering Machine/Fax mode (page 55)
“FAX ONLY”: Fax only mode (page 56)
Code #80: Resetting advanced features to their default settings
SET DEFAULT
RESET=NO [±]
To reset the advanced features:
1.Press {MENU}.
2.Press {#}, then {8}{0}.
3.Press {A} or {B} repeatedly to select “YES”.
4.Press {SET}.
5.Press {SET} again.
6.Press {MENU}.
Note:
LThe ECM selection (feature #68 on page 70) will not be reset.
70
