3. Preparation
24
Volume
3.5 Adjusting handset volume

Ringer volume

1. Press {j/OK}.
2. Select Handset Setup, then press {>}.
3. Select Ringer Setup, then press {>}.
4. Select Ringer Volume, then press {>}.
5. Press {e} or {v} repeatedly to select the
desired volume.
6. Press {>}.
7. Press {ih}.
Note:
LAlarms will sound and the handset will ring
for intercom calls and when paged even if the
ringer is turned OFF.
Ring tone
You can select one of 15 ring tones for outside
calls and intercom calls (page 75). Caller ID
service users can also use a different ringer for
each category (page 36).

Receiver volume

While using {C} or {INT}, press {e} or {v}.

Speaker volume

While using {s}, press {e} or {v}.
3.6 Adjusting base unit volume

Ringer volume

While the unit is idle, press {A} or {B}.
LIf any documents are in the document
entrance, you cannot adjust the volume.
Confirm that there are no documents in the
entrance.
To turn the ringer OFF
1. Press {B} repeatedly to display RINGER
OFF= OK?.
2. Press {SET}.
LWhen a call is received, the base unit will not
ring and will display INCOMING CALL.
LTo turn the ringer back ON, press {A}.
Ring tone
You can select the ring tones from one of 3 tones
for outside calls (feature #17 on page 67).

Speaker volume

While using the speakerphone, press {A} or
{B}.

Answering machine volume

While listening to messages, press {A} or
{B}.
{ih}

{INT}

{j/OK}
{C}
{s}
{>}{e}{v}

{SET}{A}{B}

FC235AL-PFQX2248ZA_en.book Page 24 Monday, June 20, 2005 2:19 PM