Zenith HCS5610 warranty Cloning Connections/Learning Setup, G E 5

Cloning Connections/Learning Setup

Connections for the LT2002 Clone Programmer to Learn the TV/STB Master TV Setup.

THE CLONE HAS CONTROL OF THE TV

THE CLONE IS VERSION	XX
THE TV IS VERSION	XX
THE SW IS REVISION	XX
CLONE CLOCK=	XX:XX
TV CLOCK=	XX:XX

-PRESS ANY KEY TO CONTINUE.

-DISCONNECT CLONE WHEN DONE.

3.5mm Stereo Plug

with IR Receiver

QuickSet II Programmer

LT2002

Ferrite Core (TDK, ZCAT 2035-0930)

				.	.	.	.
	.	.	.	.	.	.
.	.	.	.
. .	.	.

DVI

AC OUT 8A AC IN 120V~60Hz

		AUDIO IN		AUDIO OUT		SERVICE
REMOTE
IN
RJP
INTERFACE	1		2		DIGITAL AUDIO
AUX		DIGITAL		DIGITAL		DISPLAY
CONTROL		VIDEO IN		VIDEO OUT	OUT (OPTICAL)	CONTROL

Antenna

Wall Jack

RF Coaxial Wire	AC Power
(75ohm)	Cord

*Notes: It is assumed that the TV/STB is connected to a signal source, the source selected is Antenna (RF) In, the signal is from an Analog channel, not a digital channel, all equipment is connected to power and turned on and the LT2002 Clone

Programmer main menu (THE CLONE HAS CONTROL OF THE TV) menu is displayed on the TV screen, the clone programmer LED is blinking the required heart beat pattern, see above and next page.

*Notes: Once the clone is connected, do not touch the unit or otherwise disturb it or the MPI connections. Any disturbance while the clone is operating may disrupt the master setup transfer or copying etc.

Before you begin cloning...

•The Master TV/STB should be connected to a good, stable sig- nal from an over-the-air antenna or cable service Analog chan- nel and connected to power. (See above.)

•Teaching and Learning is only possible between identical model devices. (However, the LT2002 Clone programmer can store up

to 3 different ‘master’ setups.)

WARNING: Copying a blank or incorrect memory into a TV, STB or other device will cause the TV, STB or other device to operate erratically or become inoperable.

•Use an Installer’s remote to operate Learning and Teaching menus.

•Make sure that the batteries in the Clone programmer are fresh.

•If batteries are removed, the Clone Clock time will be lost.

•Decide if you want to set the time from the Clone programmer TV which has the clock set to the current time.

•Setting the time and transferring it to the Clone or other device is a separate procedure.

•Follow the connection diagram above to connect the Clone to a Master TV/STB display panel. After learning is

complete, to another identical TV/STB display panel to “teach” it the master setup.

•After the TV/STB setup has been copied to another identical TV/STB, that identical unit with the copied setup, needs to be disconnected from power for about 15 seconds to activate the newly-copied setup.

•See the Clone Troubleshooting section to resolve problems.

Turn to the next page to continue Cloning Setup.

P A G E 5 0