Zenith L20V54S Antenna Hookup, Connect an off-air antenna to the LCD TV/Monitor, Mini glossary

Antenna Hookup

Connect an off-air antenna to the LCD TV/Monitor.

1

2

3

Locate the Antenna/Cable jack on the back of the LCD TV/Monitor.

Connect the antenna wire (Flat or Round) that runs from the wall to this jack, according to one of the diagrams shown to the right.

After all connections are complete, plug in the TV. The LCD TV/Monitor is designed to operate on AC power.

If the antenna is a 75 ohm RF cable, then no adapters are required.

A 300 to 75 ohm adapter is not included with the Zenith LCD TV/Monitor.

RS-232C	FUTURE	SPEAKER SWITCH
		PILLOW	NORMAL
SELECT	USE	SPEAKER	SPEAKER

CONTROL NORMAL (DTV)

Connections Panel

Flat Wire (300 ohm)

RS-232C	FUTURE	SPEAKER SWITCH
		PILLOW	NORMAL
SELECT	USE	SPEAKER	SPEAKER

CONTROL NORMAL (DTV)

Connections Panel

300/75 ohm Adapter

RF Coaxial Wire (75 ohm)

Mini glossary

75 OHM RF CABLE

300 TO 75 OHM ADAPTER

The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire sticking through the middle, and it screws onto the threaded jack on the back of the TV.

A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws on one end and a round opening with a wire sticking out on the other end.

P A G E 9