Zenoah PSZ2401 manual Operation, English, STOPPING ENGINE OP4, Checking Oil Supply, Chain oil

OP6

English

8. Operation

NOTE

1.When restarting the engine immediately after stopping it, leave the choke open.

2.Overchoking can make the engine hard to start due to excess fuel. When the engine failed to start after several attempts, open the choke and repeat pulling the rope, or remove the spark plug and dry it.

■STOPPING ENGINE (OP4)

1.Release the throttle lever and run the engine for a half minute.

2.Shift the ignition switch to the “Stop” position. (OP4)

IMPORTANT

•Except for an emergency, avoid stopping the engine while pulling the throttle lever.

■CHECKING OIL SUPPLY

•After starting the engine, run the chain at medium speed and see if chain oil is scattered off as shown in the figure. (OP6)

(1) Chain oil

NOTE

The oil reservoir has a capacity sufficient to provide about 40 minutes of cutting time (when set to deliver the minimum flow rate, or about as long as you'll get from a tank of fuel). Be sure to refill the oil tank every time when refueling the saw.

■ADJUSTING OIL FLOW RATE

WARNING

Never fill the oil reservoir nor adjust the oiler with the engine running.

IMPORTANT

An increase in bar oil flow rate will speed oil consumption, requiring more frequent checks on the oil reservoir. To ensure sufficient lubrication, It may be necessary to check the oil level more frequently than at fuel tank refills.

36