Chapter 2: Installing the AP+2 as an Ethernet Client 15
3
33
3 From the Operating Mode drop-down list, select either
Client Bridge (Infrastructure) or Client Bridge (AdHoc).
If you are using the AP+2 with a gaming device, select the
Infrastructure option.
4
44
4 Click the Save Changes button.
5
55
5 When a confirmation message appears, click OK to change the
operating mode. Another message will appear letting you know
that it may take a few moments while the unit resets itself and
changes mode. Click OK. (Once the AP+2 reboots itself, you
will be prompted to log into the Web Management Interface
again.)
6
66
6 Click Wireless in the left navigational menu, then click Site
Survey. The page that opens lists the wireless networks
detected by the AP+2. Click the SSID of the network you
want to be a part of, then click OK when asked to confirm this
choice.
7
77
7 If the wireless network you just selected has security applied,
click WPA Configuration or WEP Configuration
(depending on the security used for that network) in the left
navigational menu. Specify the same security settings as the
network, then click the Save Changes button. This will allow
your AP+2 to access the wireless network. (If you need help
specifying security on the AP+2, refer to Chapter 4: Setting
Security on page 21.)
8
88
8 Click the Logout icon at the top right of the screen, then close
your Web browser.
9
99
9 Reset the computer’s TCP/IP settings to what they were
before you changed them.