Troubleshooting
Troubleshooting
Problem | Remedy | |
Batteries are used up | Are manganese batteries being used? Alkaline | |
quickly | batteries are recommended. | |
"CRDERR" (Card Error) is | The contact strip of the SmartMedia may be | |
dirty. Clean it by lightly wiping it with a soft | ||
displayed | ||
cloth. | ||
| ||
|
| |
| Card may not be fully inserted. Remove card | |
"NOCARD" is displayed | and insert again. | |
| ||
when SmartMedia card is | Newly bought SmartMedia card without system | |
inserted | ||
data was inserted. Format card and place system | ||
| ||
| data on it (➝ page 73). | |
|
| |
"FULL" is displayed | Remaining capacity of SmartMedia is | |
insufficient. Erase unneeded audio data | ||
| (➝ page 54, 59, 60). | |
|
| |
Rhythm and audio track | Wrong menu is selected. Change menu and then | |
sound is not heard, also | ||
operate slider. | ||
when turning slider up | ||
| ||
|
| |
Signal from [INPUT] jack | MIXEFX effect is being used. | |
Input level slider is turned down. Turn up slider | ||
is not heard | ||
| 1 at Song menu. | |
|
| |
Sound from [INPUT] jack |
| |
(guitar etc.) is extremely | MICPRE effect is being used. | |
distorted |
| |
|
| |
CAB (Cabinet Simulator) | If amp modeling effect type is selected in | |
module cannot be used | DRIVE module, CAB module cannot be used. | |
|
| |
Cannot record signal | "AUX" not selected as recording source | |
from [AUX] jack | (➝ page 53). | |
Bouncing to stereo was | PAN setting was not carried out for bounced | |
carried out, but sound | ||
tracks (➝ page 55). | ||
stage is narrow | ||
| ||
If MICPRE is not selected for DRIVE module, | ||
cannot be used | ||
|
|
78