ZyXEL Communications 2864I Prestige Front Panel, Connecting a Power Adapter to your Prestige

∙Straight through cable (white tag): Connect your Prestige to a 10Base-T hub.

∙Crossover cable (red tag): Connect your Prestige to your computer directly without a hub.

2￿127(￿ ,)￿7+,6￿&$%/(￿,6￿86('￿72￿&211(&7￿,6'1￿￿,7￿0$<￿'$0$*(￿<285￿35(67,*(￿

∙AUI

The AUI port (the connector with 15 pins) is used to connect the Prestige to a 10Base5 (thicknet) network.

If you have a 10Base2 network using BNC connectors and thin coaxial cables, you will need a transceiver between the AUI port and the 10Base2 cabling.

Connecting a Power Adapter to your Prestige

Plug a 16VAC 1200mA power adapter into the outlet on the rear panel of the Prestige labeled POWER

At this point, you should have connected the RS-232 cable, the ISDN phone line, the Ethernet cable, and the power supply. You can now power on your Prestige.

Prestige Front Panel

Names and descriptions of the Prestige front panel LEDs are listed below:

Figure 3-2 Front Panel

24 Installation