ZyXEL Communications 3356P-LAN user manual Extended AT& Command Set

Command	Options	Function & Description
	Z0	Reset and recall user profile 0. Either Z0 or
		Z1 restores the same single profile.

*Manufacturer default

Extended AT& Command Set

Command	Options	Function & Description
&Cn		Data carrier detect option
	&C0	State of carrier from remote modem is ignored. DCD circuit is always on
	&C1 *	DCD turns on when the remote modem’s carrier signal is detected, and
		off when the carrier signal is not detected.
&Dn		Data Terminal Ready (DTR) option.
	&D0	DTR ignored
	&D1	Go to command mode on on-to-off DTR transition
	&D2 *	Hang up and go to command mode on on-to-off DTR transition. Auto-
		answer is disabled if DTR is low
	&D3	Hang up and reset from user profile 0 on the on-to-off DTR transition
&F		Recall factory default setting as active configuration
&Gn		V.22bis guard tone option
	&G0 *	No guard tone
	&G1	550 Hz guard tone
	&G2	1800 Hz guard tone
&Kn		Set local flow control
	&K0	Disable flow control
	&K3 *	Enable bi-directional hardware flow control (CTS/RTS)
	&K4	Enable bi-directional software flow control (XON/XOFF)
&Pn		Pulse dialing make/break ratio selection
	&P0	Make=39%, Break=61%, international version (Default)
		Make=33%, Break=67% for use in 20 pps, Japanese version
	&P1	Make=33%, Break=67%, international version
		Make=33%, Break=67% for use in 10 pps, Japanese version (Default)
&Qn		Async communications mode options
	&Q0	Async mode, buffered (same as “AT\N0”)
	&Q5 *	Error control mode, buffered (same as “AT\N3”)
	&Q8	MNP error control mode. If an MNP error control protocol is not
		established, the modem will fallback according to the current setting in
		S36 register.
	&Q9	V.42 or MNP error control mode. If neither error control protocol is
		established, the modem will fallback according to the current setting in
		S36 register.
&Sn		Data Set Ready (DSR) option
	&S0 *	DSR always on
	&S1	DSR on during handshake and on-line, off in test mode or idle mode
&Tn		Self-test commands
	&T0	Terminate any test in progress
	&T1	Local analog loopback test
	&T3	Local digital loopback (LDL) test
	&T6	Remote digital loopback test
&V		View active file and stored phone numbers

AT Command Set Summaries 23