NETGEAR NETGEAR Snmp Community Commands, Show snmpcommunity, Client IP Address, Client IP Mask

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

ServPort Configuration Protocol Current Indicates what network protocol was used on the last, or current power-up cycle, if any.

Burned in MAC Address The burned in MAC address used for in-band connectivity.

SNMP Community Commands

show snmpcommunity

This command displays SNMP community information. Six communities are supported. You can add, change, or delete communities. The switch does not have to be reset for changes to take effect.

The SNMP agent of the switch complies with SNMP Version 1 (for more about the SNMP specification, see the SNMP RFCs). The SNMP agent sends traps through TCP/IP to an external SNMP manager based on the SNMP configuration (the trap receiver and other SNMP community parameters).

Format	show snmpcommunity
Mode	Privileged EXEC

SNMP Community Name The community string to which this entry grants access. A valid entry is a case-sensitive alphanumeric string of up to 16 charac- ters. Each row of this table must contain a unique community name.

Client IP Address -	An IP address (or portion thereof) from which this device will
	accept SNMP packets with the associated community. The
	requesting entity's IP address is ANDed with the Subnet Mask
	before being compared to the IP Address. Note: that if the Subnet
	Mask is set to 0.0.0.0, an IP Address of 0.0.0.0 matches all IP
	addresses. The default value is 0.0.0.0
Client IP Mask -	A mask to be ANDed with the requesting entity's IP address
	before comparison with IP Address. If the result matches with IP
	Address then the address is an authenticated IP address. For
	example, if the IP Address = 9.47.128.0 and the corresponding
	Subnet Mask = 255.255.255.0 a range of incoming IP addresses
	would match, i.e. the incoming IP Address could equal
	9.47.128.0 - 9.47.128.255. The default value is 0.0.0.0
Switching Commands	8-27

202-10088-01, March 2005