NETGEAR NETGEAR user manual Address Resolution Protocol ARP Commands, Arp, No arp

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

Chapter 10

Routing Commands

This chapter provides a detailed explanation of the Routing commands.

Address Resolution Protocol (ARP) Commands

This chapter provides a detailed explanation of the ARP commands. The commands are divided by functionality into the following different groups:

•Show commands are used to display switch settings, statistics and other information.

•Configuration Commands are used to configure features and options of the switch. For every configuration command there is a show command that will display the configuration setting.

•Copy commands are used to transfer configuration and informational files to and from the switch.

arp

This command creates an ARP entry. The value for <ipaddress> is the IP address of a device on a subnet attached to an existing routing interface. <macaddr> is a unicast MAC address for that device.

The format is 6 two-digit hexadecimal numbers that are separated by colons, for example 00:06:29:32:81:40.

Format	arp <ipaddress> <macaddr>
Mode	Global Config
no arp

This command deletes an ARP entry. The value for <arpentry> is the IP address of the interface. The value for <ipaddress> is the IP address of a device on a subnet attached to an existing routing interface. <macaddr> is a unicast MAC address for that device.

Format	no arp <ipaddress> <macaddr>
Routing Commands	10-1

202-10088-01, March 2005