NETGEAR NETGEAR user manual Class of Service CoS Commands, Classofservice dot1p-mapping

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

Policy Name	The name of the policy attached to the interface.
Note:	None of the counters listed here are guaranteed to be supported
	on all platforms. Only supported counters are shown in the dis-
	play output.

Class of Service (CoS) Commands

This chapter provides a detailed explanation of the software QoS CoS commands. The following commands are available in the software QOS module.

The commands are divided into these different groups:

•Configuration Commands are used to configure features and options of the switch. For every configuration command there is a show command that will display the configuration setting.

•Show commands are used to display device settings, statistics and other information.

Note: The 'Interface Config' mode only affects a single interface, whereas the 'Global Config' mode is applied to all interfaces.

classofservice dot1p-mapping

This command maps an 802.1p priority to an internal traffic class. The userpriority and trafficclass can both range from 0-7, although the actual number of available traffic classes depends on the platform. The 'no' form of this command is not supported.

Format	classofservice dot1p-mapping <userpriority> <traffic-
	class>
Modes	Global Config
	Interface Config

classofservice ip-dscp-mapping

This command maps an IP DSCP value to an internal traffic class. The ipdscp range is from 0-63 and the trafficclass range is from 0-7, although the actual number of available traffic classes depends on the platform. The 'no' form of this command is not supported.

Format	classofservice ip-dscp-mapping <ipdscp> <traffic-
	class>
11-40	Quality of Service (QoS) Commands

202-10088-01, March 2005